classroom projector

Newtonian™ 3
Portable mirror projection system. Projector sold separately.
classroom projector

How the mirror system works
Like a Newtonian telescope, our projection system uses two first-surface mirrors: a flat mirror and a curved one. Here the curved mirror is convex, spreading the image from a standard HD projector across the dome.
The unit sits along the back wall, leaving the best seats in the center free. It takes a range of standard HD projectors, so you can upgrade the projector later, and over 84 percent of the projector’s pixels reach the dome with over 95 percent of the dome covered. With practice, a Go-Dome™ and Newtonian™ 3 set up in under 30 minutes.
The Go-Vex™ mirror
The convex primary mirror is the Go-Vex™, also sold on its own for other mirror projection systems. See the Go-Vex™ mirror.
At a glance
| Optics | Flat secondary + Go-Vex™ convex primary, first-surface mirrors |
|---|---|
| Projector | Standard HD projectors (1920 × 1080 / 1200) |
| Coverage | Over 95 percent of the dome; over 84 percent of pixels on the dome |
| Newtonian™ 3 size | 24 3/8 × 11 7/8 × 6 3/8 in (61.9 × 30.2 × 16.2 cm) |
| Footprint (Newtonian™ 3) | About 60 cm wide, 30 to 45 cm deep |
| Retail | Newtonian™ 3: $4,053.50 |
Packs up to travel
The mirror system closes into its own case, so it travels with the dome from one site to the next.

See the Newtonian™ 3 set up
A short animated guide to placing the projector and mirrors and getting a clear picture on your dome.
Newtonian™ 3 at work
Guides & Documents
- Newtonian™ 3 and Go-Vex™ brochure pageFrom the 2026 product brochure, PDF, 1 page
- Newtonian™ 3 setup and care manualSetting up and caring for the projector, PDF, 5 pages
- 2027 retail price list, Newtonian™ 3, Go-Vex™ and accessoriesRetail estimates, PDF, 1 page
- Newtonian™ 3 specification sheetSizes and key specifications, PDF, 1 page
Newtonian™ 3 in detail

















